From design to dispatch, every process under one roof

Design, pattern making, melting and casting, heat treatment, machining, balancing and inspection, all done in-house at our Kolhapur works.

Inside our works

Made by our own hands, checked by our own eyes

Moulding, casting and machining happen on our own shop floor in Kolhapur, not at a supplier's.

Darya foundry worker drying a propeller mould cavity with a torch before casting
Mould preparationEach mould cavity is dried with a torch before the metal is poured, so the casting comes out sound and free of gas defects.
Close-up of a machined propeller hub bore and keyway at Darya Industries
Machined to fitThe hub bore is machined to your shaft size, so the propeller seats true and runs without vibration.

Melting and casting shop

  • Induction furnace
  • Digital immersion pyrometers
  • Bottom-pouring ladles
  • Green sand, CO₂ sand, no-bake sand and shell moulding
  • Shot blasting, gas cutting, grinding and fettling

Heat treatment

  • Six-point temperature scanner, uniformity within ±15 °C
  • Stress relieving and annealing
  • Normalising and tempering
  • Solution annealing
  • Quenching within 30 seconds using a fork-lifting crane

Pitch and dimensional inspection

  • Pitch measured on every blade with a pitchometer
  • Diameter checked against the design
  • Bore and keyway gauged to your shaft

Balancing and finishing

  • Static and dynamic balancing of every propeller
  • Blade grinding and edge finishing
  • Polished or hammered surface finish
  • Final visual check before dispatch

Not sure which propeller fits your boat?

Send your engine, gearbox ratio and boat length on WhatsApp. We will suggest the diameter, pitch and metal.

Talk to us in मराठी, हिंदी or English.